Steel Fibers in Shotcrete

  1. Inicio
  2. /
  3. Soluciones para proyectos
  4. /
  5. Hormigón proyectado

The Advantage of Steel Fibers in Shotcrete

Las fibras TenaBrix® para hormigón proyectado que cumplen con la norma ASTM C 1116, Especificación estándar para hormigón proyectado reforzado con fibras, y se utilizan específicamente para controlar y mitigar el agrietamiento por contracción plástica, aumentar la durabilidad de la superficie, el impacto y la resistencia a la abrasión.

Los productos TenaBrix®, que incluyen macro/microfibras sintéticas, proporcionan un refuerzo tridimensional para aplicaciones tanto sobre el suelo como bajo tierra. 

Scope of application

Tunnel initial support, slope support, mine tunnel, building reinforcement and other wet/dry spraying concrete projects.

Recommended amount of steel fiber added

Type
Recommended Addition Amount
Fiber Specification Recommendations

Primary tunnel support

25~40 kg/m³

Length 30~35mm, Diameter 0.5~0.75mm

Thin layer repair (<100mm)

35-45 kg/m³

Length 25~30mm

High-impact construction

40-60 kg/m³

Length 35~50mm, End Hook Type

The specific dosage should be verified by trial mixing to meet the requirements of flexural toughness of “steel fiber concrete” (JG/T 472).

FAQ

Exposed fibers on the surface of the spray coat

Reason:Improper spraying angle or troweling after final set.
Solution:Adjustment of gun angle; calendering before initial setting

Frequent clogging of pipes

Reason:Fiber clumping or too low a sand ratio.
Solution:Enhance fiber dispersion; increase sand rate 2%~3%

Early cracking

Reason:Uneven fiber distribution or insufficient maintenance.
Solution:Optimize mixing process; cover and maintain within 6h after spraying

Intensity fluctuation >15%

Reason:Metering deviation or uncontrolled water-cement ratio.
Solution:Calibrated fiber scale; strict water control

¿Desea más información o una muestra gratuita?

Nuestro equipo se pondrá en contacto con usted en un plazo de 12 horas